Kevin Copley
The DC one will not move on dcc, the dcc one should. do you have all of your cv's programmed?
January 26, 2012
Bill ShanamanOK when you set CV30 to 2, did you turn the power off and then on again? If you didn't then the decoder won't reset. If you did turn the power off then on again and the sound came on immediately then the reset did NOT take and you will have to do it ove... moreOK when you set CV30 to 2, did you turn the power off and then on again? If you didn't then the decoder won't reset. If you did turn the power off then on again and the sound came on immediately then the reset did NOT take and you will have to do it over again. CV30=2-turn off the MRC system-turn it back on again. The power LED (Red) on the decoder should light but you should hear no sounds for 6 seconds. Then it should start the sounds. This means it took. It will run on address 3. Check to see that it runs on 3 then you can change the loco address. Tsunami's are notorious for doing this the first time. It has something to do with the way the software is loaded into the memory. Resetting a Tsunaim is now standard procedure when I intall one. less
January 27, 2012
Bill Shanaman
Nothing wrong with the system. I just realized you bought this used. Set CV19 to 0. It could have been in a consist on a previous layout and the owner did not take it out of one before he sent it to you. Try that also.
January 27, 2012
Larry (NS-CSXDUDE) Menegay
sounds to me that it`s the decoder it could be fried or not put in right is the decoder cracked that can do that in shiping
